THE TOPCOAT
Articles

Longer deep dives

When a topic needs more than a short note: the method, the standard behind it, and where it stops being useful.

Concrete · 17 November 2026

Is the concrete dry enough to coat? What the moisture tests actually tell you

The floor coating looked fine on handover. A few weeks later there are blisters, some of them full of liquid, and the coating lifts in patches. The slab had been poured more than a month…

All substrates · 5 November 2026

How to read a coating data sheet, and what it leaves out

It's 30 °C on site, the two-pack is mixed, and the data sheet gives one pot life figure. What that figure doesn't tell you is the temperature it was measured at, and a warm mix can run out…

Steel · 29 October 2026

Dew point and surface temperature: what the 3 °C rule covers, and what it doesn't

It's a cold, clear morning. The blast-cleaned steel looks dry and feels dry. The air isn't especially humid. And there's still a film of water on it that nobody can see.